Maestralino Manual Rev5T2_1 - Aria Ventilatori
Maestralino Manual Rev5T2_1 - Aria Ventilatori
Maestralino Manual Rev5T2_1 - Aria Ventilatori
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
— REMOTE CONTROL INSTRUCTIONS —<br />
for<br />
THE MAESTRALINO<br />
After the ceiling fan has been installed a beep will be heard when the<br />
power is first turned on and when a remote button is answered.<br />
A four-channel remote control is provided to operate the fan.<br />
The remote control works as follows:<br />
• When pressing the “Low” button for about 1/2 second the fan will<br />
turn clockwise at a speed of about 60 rotations/per minute<br />
• When pressing the “Med” button for about 1/2 second the fan will turn clockwise<br />
at a speed of about 120 rotations/per minute<br />
• When pressing the “Hi” button for about 1/2 second the fan will turn clockwise<br />
at a speed of about 200 rotations/per minute<br />
• When pressing the “Stop/Rev” button for about 1 second the fan will stop<br />
• When pressing the “Stop/Rev” button for about 4 seconds the fan will turn anti-clock<br />
wise at a speed of about 60 rotations/per minute<br />
• When pressing the “Med” button for about 1/2 second the fan will turn anti-clockwise<br />
at a speed of about 120 rotations/per minute<br />
• When pressing the “Hi” button for about 1/2 second the fan will turn anti-clockwise<br />
at a speed of about 200 rotations/per minute<br />
• When pressing the “Stop/Rev” button for about 1 second the fan will stop.<br />
• When changing the direction of the fan from anti-clockwise to clockwise, press the “off”<br />
button for 1/2 second. Wait for the fan to slow then press the desired speed button<br />
(LOW, MED or HIGH) to turn the fan clockwise at the selected speed. When pressing<br />
any key, the small LED on the remote should blink rapidly. If it does not, the battery<br />
needs replacement. The #27 battery is available at most stores, accessed by a small<br />
phillips screw on back.<br />
REPROGRAMING THE REMOTE:<br />
Upon replacement of the remote transmitter or if the fans fails to recognize the<br />
remote transmitter you will need to program the remote receiver as follows:<br />
1. Turn off the power to the fan for at least 30 seconds, either at the wall switch on<br />
circuit breaker.<br />
2. In range of the fan, press and hold the LOW speed button on the remote<br />
transmitter & turn on the fan power back on.<br />
3. After about 5 seconds, the fan should beep multiple times, then start in low speed.<br />
Release the remote button & try the other buttons allowing at least 5 seconds between<br />
selections.