Maestralino Manual Rev5T2_1 - Aria Ventilatori
Maestralino Manual Rev5T2_1 - Aria Ventilatori Maestralino Manual Rev5T2_1 - Aria Ventilatori
Photo #1: Mount hanging bracket Photo #2: Insert rubber ring into hanging bracket Photo #3: Put fork into hanging bracket Photo #4: Insert the pin into the hole Photo #5: Tighten the bolts on the bracket Photo #6: Tighten the bolt of the pin or secure cotter pin Photo #7: Slide canopy upwards adjusting to 1/16” allowance Photo #8: Tighten the screws of the canopy
— TROUBLESHOOTING GUIDE — • PROBLEM: Fan blades do not turn a. Power turned off at electrical panel b. Power turned off at wall switch c. Battery in remote is no longer operative d. Remote requires reprograming. See Remote Control Instructions — How To Reprogram the Remote. e. Loose wire connection or improper wiring • PROBLEM: Fan motor creates excessive noise when ceiling fan is turned on a. With power turned off, verify that motor spins freely on stem. See Installation Instructions – Step 6 b. Verify only stranded wire is connected to the terminal block and solid wire and connections are pushed up in the j-box. c. Verify rubber grommet is not compressed against the ceiling or electrical box. Install washers above strap to ease. d. Tighten screw holding canopy to stem until tight then back off ½ turn. e. Rotate canopy slightly. • PROBLEM: Fan creates noise when blades turn: a. Fan blades installed in wrong positions, the number on blade must match the number on the hub b. Verify canopy is not touching the ceiling, adjust canopy position slightly and verify wires are not overly compressed in canopy. • PROBLEM: Fan has excessive wobbling a. Fan blades are loose and set screws not adequately tightened b. Fan is not hanging correctly on fan hanging bracket. Verify bracket is aligned with slope of ceiling if applicable. • FOR OTHER PROBLEMS: If this Troubleshooting list does not help to solve the problem, please contact us at 888.640.5550
- Page 1 and 2: A R I A V E N T I L AT O R I — TH
- Page 3 and 4: Step 1: Note for Electrician — IN
- Page 5: Step 6: Verify Fan Motor Rotates Fr
Photo #1: Mount hanging bracket Photo #2: Insert rubber ring into hanging bracket<br />
Photo #3: Put fork into hanging bracket Photo #4: Insert the pin into the hole<br />
Photo #5: Tighten the bolts on the bracket Photo #6: Tighten the bolt of the pin or secure<br />
cotter pin<br />
Photo #7: Slide canopy upwards adjusting to<br />
1/16” allowance<br />
Photo #8: Tighten the screws of the canopy
Change language