Flexocure XS Flexocure XS

More documents

Recommendations

Info

Smallest (cm) Widest (cm) Void to allow process (cm) Shrink % Kefir 13,7 27,5 1,5 53% Wave 12,5 24,7 1,5 52% Coca Cola 18,3 1,5 60% Shrink calculation: 1- (Smallest/(widest+void)) 8 Smyth 9,5 23,5 1,5 62% Harpic 12 23,4 1,5 > 70% Shrink examples/
Current issues using UV inks � How to combine High Opacity with good shrinkage? –Opacity proportional to ink layer – but difficult to cure – Too thick layer cause bad shrink performance. – Recommend to try to use 2 layer of Opaque White – and as little as possible in high shrink areas – print white in dots (for ex 60-70% as when the dots shrink they for solid area). � Metallic inks – not loosing metallic effect – 15-20% shrinkage using right metallic inks � Low odour UV technology is available – but is it low enough? � Thick layers of ink resulting in “relief” effect after shrinking
Page 1 and 2: Flexocure XS Maximum Shrink - Expan
Page 3 and 4: UV inks for sleeves � Technical c
Page 5 and 6: Flexocure XS is better in print qua
Page 7 and 8: Sleeve welding Film roll Solvent ap
Page 9 and 10: Steam Tunnel Typical characteristic
Page 12 and 13: Material is OPS - difference betwee
Page 14 and 15: Inks for Sleeves Low Shrink < 25% M
Page 16 and 17: Flexocure XS - shrink sleeve succes
Page 20 and 21: Flexocure XS facts Adhesion Odour P

Flexocure XS Flexocure XS

Create successful ePaper yourself

Delete template?

Save as template?