Flexocure XS Flexocure XS

More documents

Recommendations

Info

<strong>Flexocure</strong> <strong>XS</strong> - shrink sleeve success � Surface tension > 38 dyne � Chiller drums to be set at 20°C / 68°F per unit � First unit should be 20°C / 68°F, last unit should not exceed 30°C / 86°F � Use hard plate as this will reduce pinholes � 2 hits with “normal” lay down gives better shrink ability then 1 heavy ink lay down.
Anilox Recommendations Lines/cm Lines/inch Parameters Volume (cm 3 /m 2 ) Angle (deg) Film weight (g/m 2 ) UV lamps (W/cm) Print speed m/min * Only suitable for opaque white, due to its density Pantone ® 160-180 400-460 5-6 60 1,6-1,8 160 80 -150 Solids 120-180 300-460 5-10* 60 1,6-3,0 160 80 -150 Process 300-400 760-1270 3-4 60 1,0-1,2 160 100 - 150
Page 1 and 2: Flexocure XS Maximum Shrink - Expan
Page 3 and 4: UV inks for sleeves � Technical c
Page 5 and 6: Flexocure XS is better in print qua
Page 7 and 8: Sleeve welding Film roll Solvent ap
Page 9 and 10: Steam Tunnel Typical characteristic
Page 12 and 13: Material is OPS - difference betwee
Page 14 and 15: Inks for Sleeves Low Shrink < 25% M
Page 18 and 19: Smallest (cm) Widest (cm) Void to a
Page 20 and 21: Flexocure XS facts Adhesion Odour P

Flexocure XS Flexocure XS

Create successful ePaper yourself

Delete template?

Save as template?