Quick R eference Guide - emitec-industrial.ch
Quick R eference Guide - emitec-industrial.ch
Quick R eference Guide - emitec-industrial.ch
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
RFC2544<br />
VePAL TX300<br />
<strong>Quick</strong> R<strong>eference</strong> <strong>Guide</strong><br />
Configuration (cont’d)<br />
10. Select the frame sizes to test<br />
− Go to the Frames tab to select the different frame sizes<br />
to test.<br />
Check the box to the<br />
right of ea<strong>ch</strong> frame size<br />
to test.<br />
To test a frame size<br />
d i f fe r e nt from the<br />
recommended frame<br />
sizes, press ‘Add Frame’<br />
to add up to two user<br />
configurable frame sizes.<br />
11. Configure the control commands to loop up and loop down<br />
the far end test partner (another TX300).<br />
− Enter the Destination IP address. This is the local IP<br />
address of the far end unit.<br />
User must manually<br />
s e n d t h e L o o p U p<br />
command before the<br />
start of the test and<br />
manually send a Loop<br />
Down command after<br />
the test has ended.<br />
Note: If the far end test partner is already in loopback mode<br />
(preconfigured locally at the far end), there is no need to make<br />
use of the Control window.
Change language