ingersoll rand aro compact series - ToolSmith

More documents

Recommendations

Info

PRODUCT SELECTION INGERSOLL RAND • FILTERS, REGULATORS, AND LUBRICATORS (FRLs) | 65 When selecting an FRL or individual filter, regulator, and lubricator units, the air consumption of the tools or equipment to be serviced should be correlated with the flow capacity of the FRL. Ingersoll Rand ARO filters, regulators, and lubricators are designed to flow in excess of that indicated in the maximum recommended flow table shown below. This table gives recommended flows for pipe sizes at listed pressures and should be used as a guide in sizing piping and equipment for compressed air systems. MAXIMUM RECOMMENDED AIRFLOW (CFM) THROUGH A.N.S.I. STANDARD WEIGHT SCHEDULE 40 PIPE.* Applied Pressure Nominal Standard Pipe Size psig 1/8" 1/4" 3/8" 1/2" 3/4" 1" 1-1/4" 1-1/2" 2" 2-1/2" 3" 5 0.5 1.2 2.7 4.9 6.6 13 27 40 80 135 240 10 0.8 1.7 3.9 7.7 11 21 44 64 125 200 370 20 1.3 3 6.6 13 18.5 35 75 110 215 350 600 40 2.5 5.5 12 23 34 62 135 200 385 640 1100 60 3.5 8 18 34 50 93 195 290 560 900 1600 80 4.7 10.5 23 44 65 120 255 380 720 1200 2100 100 5.8 13 29 54 80 150 315 470 900 1450 2600 150 8.6 20 41 80 115 220 460 680 1350 2200 3900 200 11.5 26 58 108 155 290 620 910 1750 2800 5000 250 14.5 33 73 135 200 370 770 1150 2200 3500 6100 *The flow values in the chart above are based upon a pressure drop (▲P) as set forth in the following schedule: Pressure (▲) per 100' of Pipe Pipe Size Compressed air 10% of applied pressure 1/8", 1/4", 3/8", 1/2" 5% of applied pressure 3/4", 1, 1-1/4", 1-1/2", 2, 2-1/2", 3" INSTALLATION The filter, regulator, and lubricator should be installed in the order shown in the illustration below. If a coalescing filter is required, it should be installed downstream from a standard filter. Individual take-off lines to the FRL and air tool or equipment should be from the top of the compressed air line. Make sure that airflow markings are followed for proper flow direction through the FRL units. To trap and expel water, sludge, and other contaminants which may collect on the bottom of the air line, a drip leg drain should be used. Drip leg drains should be installed at low points in the piping system and at the far end of the distribution system. Ingersoll Rand <strong>series</strong> with safety lock-out valve Filter Regulator Lubricator Pneumatic tool Shut-off valve Drip leg drain irtools.com • (800) 376-TOOL
66 | INGERSOLL RAND • FILTERS, REGULATORS, AND LUBRICATORS (FRLs) INGERSOLL RAND ARO ® MINI AND COMPACT SERIES MODULAR DESIGN The Modular FRL with Pipe Nipple Capability FRLs in the Mini and Compact Series have threaded ports, allowing either modular configurations or pipe nipple connections. Ingersoll Rand ARO Mini Series Ingersoll Rand ARO Compact Series Modular spacer T-type wall bracket Pipe nipple connection irtools.com • (800) 376-TOOL Right angle piping bracket Threaded pipe adapters U-bolt mounting bracket Modular connection Wall mounting kit
Page 1 and 2:
Ingersoll Rand Industrial Technolog
Page 3 and 4:
AT EVERY TURN, WE’RE COMMITTED TO
Page 5 and 6:
TABLE OF CONTENTS (CONTINUED) WORK
Page 7 and 8:
6 | INGERSOLL RAND NOTES irtools.co
Page 9 and 10:
8 | INGERSOLL RAND NOTES irtools.co
Page 11 and 12:
POWER SUPPLY ACCESSORIES Compressor
Page 13 and 14:
10 | INGERSOLL RAND • COMPRESSOR
Page 15 and 16:
12 | INGERSOLL RAND • COMPRESSOR
Page 17 and 18: 14 | INGERSOLL RAND • COMPRESSOR
Page 23 and 24: 20 | INGERSOLL RAND • COUPLERS AN
Page 35 and 36: 32 | INGERSOLL RAND • SIMPLAIR PI
Page 55 and 56: 52 | INGERSOLL RAND • FITTINGS AN
Page 65 and 66: 62 | INGERSOLL RAND • FILTERS, RE
Page 67: 64 | INGERSOLL RAND • FILTERS, RE
Page 103 and 104: 100 | INGERSOLL RAND • FILTERS, R
Page 119 and 120:
116 | INGERSOLL RAND • FILTERS, R
Page 121 and 122:
Page 123 and 124:
Page 125 and 126:
Page 127 and 128:
Page 129 and 130:
Page 131 and 132:
Page 133 and 134:
Page 135 and 136:
132 | INGERSOLL RAND • LIQUIDATOR
Page 137 and 138:
Page 139 and 140:
Page 141 and 142:
138 | INGERSOLL RAND • AIR LINE V
Page 143 and 144:
Page 145 and 146:
Page 147 and 148:
144 | INGERSOLL RAND • FLUID PROD
Page 149 and 150:
Page 151 and 152:
Page 153 and 154:
Page 155 and 156:
Page 157 and 158:
Page 159 and 160:
Page 161 and 162:
158 | INGERSOLL RAND • CORDLESS A
Page 163 and 164:
160 | INGERSOLL RAND • CORDLESS A
Page 165 and 166:
WORK ACCESSORIES Impact Sockets 161
Page 167 and 168:
162 | INGERSOLL RAND • IMPACT SOC
Page 169 and 170:
Page 171 and 172:
Page 173 and 174:
Page 175 and 176:
170 | INGERSOLL RAND • CONSTRUCTI
Page 177 and 178:
Page 179 and 180:
Page 181 and 182:
Page 183 and 184:
Page 185 and 186:
Page 187 and 188:
182 | INGERSOLL RAND • SANDING AN
Page 189 and 190:
Page 191 and 192:
Page 193 and 194:
188 | INGERSOLL RAND • CARBIDE GR
Page 195 and 196:
190 | INGERSOLL RAND • CARBIDE GR
Page 197 and 198:
192 | INGERSOLL RAND • SAW BLADES
Page 199 and 200:
194 | INGERSOLL RAND • COLLETS CO
Page 201 and 202:
196 | INGERSOLL RAND • COLLETS NO
Page 203 and 204:
198 | INGERSOLL RAND • DRILL ACCE
Page 205 and 206:
200 | INGERSOLL RAND • DRILL ACCE
Page 207 and 208:
202 | INGERSOLL RAND • SCREWDRIVE
Page 209 and 210:
Page 211 and 212:
Page 213 and 214:
Page 215 and 216:
USER ACCESSORIES Gloves 209 Ergonom
Page 217 and 218:
210 | INGERSOLL RAND • GLOVES GLO
Page 219 and 220:
212 | INGERSOLL RAND • ERGONOMIC
Page 221 and 222:
Page 223 and 224:
Page 225 and 226:
218 | INGERSOLL RAND • BALANCERS
Page 227 and 228:
Page 229 and 230:
Page 231 and 232:
224 | INGERSOLL RAND • POINT-OF-U
Page 233 and 234:
Page 235 and 236:
Page 237 and 238:
Page 239 and 240:
Page 241 and 242:
234 | INGERSOLL RAND • EXHAUST KI
Page 243 and 244:
236 | INGERSOLL RAND • VACUUM KIT
Page 245 and 246:
238 | INGERSOLL RAND • MUFFLERS C
Page 247 and 248:
240 | INGERSOLL RAND • PRECISION
Page 249 and 250:
Page 251 and 252:
Page 253 and 254:
Page 255 and 256:
Page 257 and 258:
Page 259 and 260:
Page 261 and 262:
Page 263 and 264:
Page 265 and 266:
COMPONENTS Lubricants 257 Repair Ki
Page 267 and 268:
258 | INGERSOLL RAND • LUBRICANTS
Page 269 and 270:
260 | INGERSOLL RAND • LUBRICANTS
Page 271 and 272:
262 | INGERSOLL RAND • REPAIR KIT
Page 273 and 274:
Page 275 and 276:
Page 277 and 278:
SERVICE THE BEST EQUIPMENT DESERVES
Page 279 and 280:
270 | INGERSOLL RAND • CERTIFIED
Page 281 and 282:
272 | INGERSOLL RAND • INDEX irto
Page 283 and 284:
Page 285 and 286:
Page 287 and 288:
Page 289:
show all

ingersoll rand aro compact series - ToolSmith

Create successful ePaper yourself

Delete template?

Save as template?