Anchor bolt TOX S FIX 1 A4

Page 10 of European technical approval ETA–07/0218, issued on 10 April 2012
English translation prepared by CSTB
Schema of the anchor in use :
Table 3: Installation data
L
(mm)
dcut
Number
of
bosses
dcut
(mm)
df
(mm)
Minimum thickness of concrete member hmin
Tinst
(Nm)
Minimum embedment depth hnom
Effective anchorage depth hef
Deepest drilled hole depth h1
Tinst
Fixture thickness tfix
Minimum embedment depth hef,min Maximum embedment depth hef,max
hmin
(mm)
h1
(mm)
hnom
(mm)
hef,min
(mm)
tfix,max
(mm)
hmin
(mm)
h1
(mm)
hnom
(mm)
hef,max
(mm)
Anchor type (0) marking (1) (2) (3) (4) (5) (6) (7) (8) (4) (5) (6) (7) (8)
M8/5 56 0 5 - - - - -
M8/20-7 71 1 20 7
M8/40-27 91 3 8 9 20 100 52 42 35* 40 100 65 55 48 27
M8/80-67 130 5 80 67
M10/5 65 0 5 - - - - -
M10/15 76,2 1 15 - - - - -
M10/35-20 96,2 3 10 12 35 100 62 50 42 35 116 78 66 58 20
M10/60-45 121,2 4 60 45
M12/5 78,7 0 5 - - - - -
M12/25-6 100 1 25 6
M12/40-21 115 2 12 14 50 100 75 60 50 40 140 95 80 70 21
M12/65-46 140 4 65 46
M16/30-8 125,2 1 30 8
M16/55-33 150,2 2 16 18 100 128 95 78 64 55 172 117 100 86 33
M16/75-53 170,2 3 75 53
* use restricted to anchoring of structural components statically indeterminated.
(0) Total length of the bolt (mm) (5) Depth of drilled hole to deepest point, h1 (mm)
(1) Nominal diameter of drill bit, dcut (mm) (6) Minimum installation depth, hnom (mm)
(2) Diameter of clearance hole in the fixture, df (mm) (7) Effective anchorage depth, hef (mm)
(3) Required torque moment, Tinst (Nm) (8) Maximum thickness of the fixture, tfix,maxi (mm)
(4) Minimum thickness of concrete member, hmin (mm)
Cracked and Non- cracked concrete M8 M10 M12 M16
Effective anchorage
depth hef,min
Effective anchorage
depth hef,max
Minimum spacing Smin (mm) 60 75 170 150
Minimum edge distance Cmin (mm) 60 65 100 100
Minimum spacing Smin (mm) 50 55 75 90
Minimum edge distance Cmin (mm) 60 65 90 105
TOX S-FIX-1-A4 torque-controlled expansion anchor Annex 3
of European Technical
Installation data
Approval
ETA-07/0218
tfix,max
(mm)