Dollar General Store Shared Hub Rollout Skystar Advantage VSAT ...

Spacenet Proprietary Information
Next, enter 123# at the password prompt. Choose No at the change password prompt.
VACS continues with the remaining parameters:
21 Main outbound frequency 33 Backup outbound frequency
22 Main channel delay 34 Backup channel delay
23 Main inbound reference frequency 35 Backup inbound reference frequency
24 Main inbound idle frequency 36 Backup inbound idle frequency
25 Main day number of inbound bands 37 Backup day number of inbound bands
26 Main day start frequency 38 Backup day start frequency
27 Main day stop frequency 39 Backup day stop frequency
28 Main night number of inbound bands 40 Backup night number of inbound
bands
29 Main night start frequency 41 Backup night start frequency
30 Main night stop frequency 42 Backup night stop frequency
31 Main inbound initial frequency 43 Backup inbound initial frequency
32 Main inbound initial frequency
Press * to repeat the parameters menu. Press 1 to enter another parameter. Press 2 to
repeat the parameter.
The Align Antenna Menu options of the Install menu are:
� Option 1. Check Alignment
� Option 2. Align Co-pol (Co-polarization)
� Option 3. Align Cross-pol (Cross-polarization).
You may have to wait for up to one minute for VACS to complete each of these
operations. If Check Alignment or Align Co-pol fails, call back and try again. If Align
Cross-pol fails, call Commissioning Group for assistance (1–800–443–5834).
NOTE: When you move the antenna, there is approximately a two second
delay before the new position registers with VACS.
NOTE: Moving the antenna too far away from the optimal position results in
loss of Rx lock. If Rx lock is lost, repeat the initial VSAT alignment as
described in the Spacenet VSAT Installation Guide, and then call VACS
again to continue.
Align Check. An align check gives the current reading of the co-pol and the cross-pol.
VACS automatically takes these measurements, then determines whether the
measurements meet the installation criteria. If they do, VACS records the
measurements, tells you that co-pol and cross-pol requirements are met, releases the
carrier wave (CW) test frequency, and returns to the Install menu.
Dollar General Skystar Advantage VSAT Installation Guide Appendix B iv