Dollar General Store Shared Hub Rollout Skystar Advantage VSAT ...

Proprietary Information
� Option 1. Quick Parameters
� Option 2. Azimuth and Elevation
� Option 3. All Parameters
� Option 4. Individual Parameters
� Option 5. Return to Install Menu.
NOTE: Use Quick Parameters when using the VSAT configuration script.
Spacenet
Before configuring the IDU, choose Quick Parameters to establish and record the
necessary VSAT parameters.
Quick Parameters. These parameters are unique to each VSAT. Press 1 to move to
the next parameter. Press 2 to repeat the parameter. Press # to stop playing the
parameters.
Azimuth and Elevation. Enter the five digit zip code of the VSAT installation site.
VACS replies with the azimuth and elevation for pointing the antenna to the satellite.
Press 1 to continue or 2 to repeat. Press # to return to the Get Parameters menu.
NOTE: If you are using the VSAT configuration script, do not use the Getting
All Parameters option.
Getting All Parameters. Use this option if you do not have a disk or document
containing the common network parameters or if you are not using the configuration
script. VACS reads all installation parameters in the order that the VSAT uses them.
Press 1 to move to the next parameter. Press 2 repeat the parameter. Press # to stop
playing the parameters.
Getting a Single Parameter. To set an individual parameter on the VSAT, enter a
number from the following list:
0 USAT own address 5 Time slot duration
1 USAT group address 6 Outbound ID
2 Outbound rate 7 Out code rate one quarter
3 Outbound modulation 8 Interleaver ID
4 Outbound Reed Solomon 9 Establish link
10 Inbound modulation 16 Inbound DA frame length
11 Inbound rate RA 17 K for inbound coding
12 Dual inbound rate 18 HPP ID
13 Inbound reed solomon 19 HSP link number
14 Inbound convolution 20 Load Probe
15 Inbound RA frame length
Dollar General Skystar Advantage VSAT Installation Guide Appendix B iii