Indoor Unit Outdoor Unit CS-E9NKUAW CS ... - Panasonic

More documents

Recommendations

Info

10.2 Outdoor Unit 10.2.1 Main Printed Circuit Board 20
11. Installation Instruction 11.1 Select the Best Location 11.1.1 Indoor Unit � Do not install the unit in excessive oil fume area such as kitchen, workshop and etc. � There should not be any heat source or steam near the unit. � There should not be any obstacles blocking the air circulation. � A place where air circulation in the room is good. � A place where drainage can be easily done. � A place where noise prevention is taken into consideration. � Do not install the unit near the door way. � Ensure the spaces indicated by arrows from the wall, ceiling, fence or other obstacles. � Recommended installation height for indoor unit shall be at least 8.2 ft. 11.1.2 Outdoor Unit � If an awning is built over the unit to prevent direct sunlight or rain, be careful that heat radiation from the condenser is not obstructed. � There should not be any animal or plant which could be affected by hot air discharged. � Keep the spaces indicated by arrows from wall, ceiling, fence or other obstacles. � Do not place any obstacles which may cause a short circuit of the discharged air. � If piping length is over the [piping length for additional gas], additional refrigerant should be added as shown in the table. � Recommended installation height for outdoor unit should be above the seasonal snow level. Example: For E9NKUAW If the unit is installed at 32.8 ft distance, the quantity of additional refrigerant should be 1.64 oz .... (32.8 - 24.6) ft x 0.2 oz/ft = 1.64 oz. 21 11.1.3 Indoor/Outdoor Unit Installation Diagram
Page 1 and 2: Order No: PHAAM1111087C1 Indoor Uni
Page 3 and 4: 1. Safety Precautions � Read the
Page 5 and 6: 2. Specification Cooling Heating In
Page 7 and 8: DRY BULB WET BULB DRY BULB WET BULB
Page 9 and 10: 4. Location of Controls and Compone
Page 11 and 12: 5.2 Outdoor Unit 11
Page 13 and 14: 7. Block Diagram 13
Page 19: 10.1.2 Power Printed Circuit Board
Page 23 and 24: 11.2.3 Indoor Unit Installation 11.
Page 25 and 26: 11.2.5 Wiring Stripping and connect
Page 27 and 28: 11.3.2.3 Connecting the piping to o
Page 29 and 30: 12. Operation Control 12.1 Basic Fu
Page 31 and 32: [Heating] o According to indoor pip
Page 33 and 34: � Control contents o Fan speed au
Page 35 and 36: 13. Operation Control (For Multi Sp
Page 37 and 38: 14. Protection Control 14.1 Protect
Page 39 and 40: 14.2.2 Cooling Overload Control �
Page 41 and 42: 15. Servicing Mode 15.1 Auto Off/On
Page 43 and 44: 16. Troubleshooting Guide 16.1 Refr
Page 45 and 46: 16.2 Breakdown Self Diagnosis Funct
Page 47 and 48: Note: “○” - Frequency measure
Page 49 and 50: 16.4.2 H12 (Indoor/Outdoor Capacity
Page 51 and 52: 16.4.4 H15 (Compressor Temperature
Page 53 and 54: 16.4.6 H19 (Indoor Fan Motor - DC M
Page 55 and 56: 16.4.8 H27 (Outdoor Air Temperature
Page 57 and 58: 16.4.10 H30 (Compressor Discharge T
Page 59 and 60: 16.4.12 H33 (Unspecified Voltage be
Page 61 and 62: 16.4.14 H37 (Outdoor Liquid Pipe Te
Page 63 and 64: 16.4.16 H98 (Indoor High Pressure P
Page 65 and 66: 16.4.18 F11 (Indoor Pipe Temperatur
Page 67 and 68: 16.4.20 F90 (Power Factor Correctio
Page 69 and 70: 16.4.22 F93 (Compressor Rotation Fa
Page 71 and 72:
16.4.24 F96 (IPM Overheating) Malfu
Page 73 and 74:
16.4.26 F98 (Input Over Current Det
Page 75 and 76:
17. Disassembly and Assembly Instru
Page 77:
17.1.1.3 To remove control board 17
Page 80 and 81:
� Piping Length Characteristic Co
Page 82 and 83:
� Piping Length Characteristic He
Page 84 and 85:
� Piping Length Characteristic Co
Page 86 and 87:
� Piping Length Characteristic He
Page 88 and 89:
REF. NO. PART NAME & DESCRIPTION QT
Page 90:
REF. NO. PART NAME & DESCRIPTION QT
show all

Indoor Unit Outdoor Unit CS-E9NKUAW CS ... - Panasonic

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?