Pedal Boat Owner's Manual - Future Beach
Pedal Boat Owner's Manual - Future Beach
Pedal Boat Owner's Manual - Future Beach
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
WB & Equinox Series Maintenance Instructions<br />
<strong>Pedal</strong> Mechanism Maintenance<br />
D1<br />
D2<br />
Disassembly of<br />
the crankshaft<br />
D3<br />
Screw type<br />
replacement bushing<br />
D4<br />
16<br />
Replacement of<br />
the crankshaft<br />
Delrin<br />
bushing<br />
Install one way<br />
aligne larger<br />
drive tooth to<br />
properly install<br />
This section of the owner’s manual describes<br />
the steps involved in disassembly of<br />
the entire unit crankshaft assembly and its<br />
components. Please note that disassembly<br />
is not required for the replacement of<br />
pedal pads or paddle blades. To remove the<br />
crankshaft assembley, use a ¾” socket or a<br />
¾” wrench, to remove the nut from one side<br />
of the crankshaft rod.<br />
Now remove the crankshaft and drive adapter,<br />
which slide out together. From the other<br />
side pull out the other crankshaft and drive<br />
adapter along with the crankshaft rod.<br />
To replace the Delrin bushing assemblies<br />
simply unscrew the back nuts located in the<br />
paddle wheel cavity and insert new parts.<br />
These parts are the most likely to wear and<br />
should be inspected periodically. These<br />
bushings should be replaced if worn, in order<br />
to prevent damage to the pedal boat<br />
hull. Inspect and replace every season as<br />
required.<br />
To reinstall the drive adapter, reverse the<br />
steps above, inserting the crankshaft and<br />
crankshaft rod through the paddle hub<br />
(make sure that paddle blades are facing<br />
their original direction). Refer to figure D5<br />
for correct paddle blade installation. Reinstall<br />
the second crankshaft. Note that the drive<br />
adapter has a single large male key that<br />
is designed to fit into the paddle hub in one<br />
unique location. You must locate this single<br />
large key correctly when installing the drive<br />
adapter in the paddle hub.