A two-state model of simple reaction time
A two-state model of simple reaction time
A two-state model of simple reaction time
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
- 53 -<br />
The experiment consisted <strong>of</strong> 7 blocks, each <strong>of</strong> which had<br />
103 trials. Each block started when the subject pressed down<br />
the left microswitch. When 0.5 sec had passed after this response,<br />
the LED lit up. The subject was instructed to press down the<br />
right microswitch as fast as possible when the LED lit up.<br />
The LED went out immediately when the subject responded. After<br />
some <strong>time</strong> (FP) had passed, the next trial began, that is, the LED<br />
lit up and the subject responded. An FP-LED-response cycle was<br />
repeated until the end <strong>of</strong> the block.<br />
In a block, 102 FPs were used. The first <strong>two</strong> FPs were 2 sec.<br />
The other 100 FPs were in a randomized sequence <strong>of</strong> 20 sets <strong>of</strong><br />
FPs. Each set consisted <strong>of</strong> 1.00, 1.30, 1.69, 2.19 and 2.84 sec<br />
FPs. It was randomized with the following restriction: 1.00, 1.69<br />
and 2.84 sec FPs were preceded by each <strong>of</strong> the members <strong>of</strong> the set,<br />
which included itself, at least <strong>two</strong> <strong>time</strong>s, respectively.<br />
The subject was allowed to rest between blocks as long as<br />
he would like to.<br />
The program for experiment III is given in appendix C.