SW4000 USER MANUAL - Nilfisk PARTS - Nilfisk-Advance

ENGLISHUSER MANUALMAINTENANCEThe lifespan of the machine and its maximum operating safety are ensured by correct and regular maintenance.The following table provides the scheduled maintenance. The intervals shown may vary according to particular working conditions,which are to be defined by the person in charge of the maintenance.All scheduled or extraordinary maintenance procedures must be performed by qualified personnel, or by an authorised ServiceCenter.This Manual describes only the easiest and most common maintenance procedures.For other maintenance procedures shown in the Scheduled Maintenance Table, refer to the Service Manual that can be consultedat any Service Center.WARNING!To perform maintenance procedures, the machine must be off, the ignition key removed, and, if necessary, thebatteries must be disconnected.Read carefully the instructions in the Safety chapter before performing any maintenance procedure.SCHEDULED MAINTENANCE TABLEProcedureUpondeliveryEvery 10hoursEvery 50hoursEvery100hoursEvery200hoursEveryyearEngine oil level check (1)Battery fluid level check (2)Side and main broom height checkEngine air filter check (1)Brake cable check and adjustment (3)Hopper dust filter check and cleaning (“A” method) (4)Hopper hydraulic lifting system oil level check (2)Skirt height and operation checkDust guard system water filter check and cleaning (optional)Engine air filter cleaning (4) (4)Hopper dust filter check and cleaning (“B” method) (4)Filter shaker operation check (*)Main broom driving belt visual inspection (*)Engine oil change (5) (6)Spark plug check/cleaningSteering chain cleaning (*)Safety system operation check (2)Engine filter trap cleaningEngine baffle plate cleaningFuel filter cleaning (7)Brake pad check/adjustment/replacement (*)(3)20 SW4000 - 1464815000