SW4000 USER MANUAL - Nilfisk PARTS - Nilfisk-Advance

USER MANUALENGLISHNOTEIf necessary, manually engage the hopper in position (A) with the returning handle (E) when the hoisting system is liftedand the hopper is disengaged (B).CAUTION!The hopper (A) can be dumped only when lifted at a minimum height of 35 cm approximately.The maximum dumping height is approx. 150 cm.5. Lower the hopper by pressing both the enabling switch (66) and the switch (79).NOTETo ensure that the hopper (11) is fully retracted, check that the warning light (74) is off.6. The machine is ready to start sweeping and vacuuming again.CEmax100 Kg(220 lb)AD1500 mm(59 in)BFigure 1AFTER USING THE MACHINEAfter working, before leaving the machine, perform the following procedures.––Turn on the filter shaker shortly, by pressing the lower part of the switch (65).––Empty the hopper (11) (see the procedure in the previous paragraph).––Lift the main broom with the lever (63).––Lift the side brooms with the lever (64).––(For LPG version). Close the safety valve on the LPG tank (56), then let the engine run until all the fuel is expelled from thehoses (then the engine is stopped).––Turn off the machine by turning the ignition key (61) to “0”, then remove it.––Engage the parking brake.MACHINE LONG INACTIVITYIf the machine is not going to be used for more than 30 days, proceed as follows:––Check that the machine storage area is dry and clean.––(For Petrol version). Close the fuel tap (34).––(For LPG version). Close the LPG tank safety valve.––Disconnect the negative connector (-) of the batteries (46).––Handle the engine (42) as shown in the relevant Manual.––(For machines equipped with dust guard system). Empty the tank (24) and clean the water filter (see the procedure inMaintenance chapter).FIRST PERIOD OF USEAfter the first 20 hours perform the following procedures:––Change the engine oil (see the procedure in Maintenance chapter).P1005921464815000 - SW4000 19