SW4000 USER MANUAL - Nilfisk PARTS - Nilfisk-Advance

ENGLISHUSER MANUALBEFORE MACHINE START-UPChecklist1. Have a full knowledge of the machine operating controls and their functions.2. Insert the key (61) and start the machine (see the procedure in the following paragraph).3. Check the fuel reserve warning light (71). If it is on, refuel with petrol or replace the LPG tank (see previous paragraph).4. Check the horn with switch (67), the reverse gear buzzer with switch (68) and the working light switch (78, optional) for properoperation.5. Check the parking brake (7 and 6). The brake must hold its (locked parked) setting firmly without easily being released (reportall defects immediately to Nilfisk Service Center).6. Check the service brake pedal (6) for proper operation.WARNING!If the pedal is “spongy” or fades under pressure without an efficient braking force, do not drive the machine(report all defects immediately to Nilfisk Service Center).7. Make sure that there are no open doors/hoods and that the machine is in normal operating conditions.Cleaning planning1. Arrange long runs with a minimum of stopping or starting.2. Allow a small amount of broom path overlap to ensure complete coverage.3. Avoid making sharp turns, bumping or scraping the side of the machine.Filling the DustGuard system water tank (optional)1. Remove the plug (25) to reach the filler neck.2. Fill the tank (24) with clean water. Do not fill the tank completely, leave a few centimetres from the edge.STARTING AND STOPPING THE MACHINEStarting the machine1. Sit on the driver’s seat (3) and adjust it with the lever (4) to allow easy reach of all controls.NOTEThe driver’s seat (3) is equipped with a safety sensor, which allows the machine to be driven only when the operator ison the driver’s seat.2. Pull the engine choke lever (55).NOTE(For Petrol version). Do not use the choke lever if the engine is hot and if the air temperature exceeds 20 °C.NOTE(For LPG version). Always use the choke lever to approximately half stroke.3. Insert the ignition key (61) and turn it clockwise to “II”. When the engine starts, release the key. Wait (a few seconds) for thedisplay (69) to turn on and sowing the working hours.CAUTION!When starting the engine do not press the drive pedal (5).If the drive system warning light (76) flashes, turn off the machine and repeat the start-up procedure.4. After the ignition, let the engine run for a few seconds, then release the choke lever (55).5. Disengage the parking brake.6. Drive the machine to the working area, by keeping the hands on the steering wheel (1) and pressing the pedal (5).The drive speed can be adjusted from zero to maximum speed by increasing the pressure on the pedal.7. The forward/reverse direction is selected with the relevant switch (68) on the dashboard. When the reverse gear is selected,the relevant buzzer turns on.8. Lower the main broom with the lever (63).9. Lower the side brooms with the lever (64).NOTEWhen the brooms are lowered, the brooms, the vacuum system and the dust guard system (optional - if turned on withthe switch (80)) automatically activates only when the machine is moving.16 SW4000 - 1464815000