13.07.2015 Aufrufe

SW4000 USER MANUAL - Nilfisk PARTS - Nilfisk-Advance

SW4000 USER MANUAL - Nilfisk PARTS - Nilfisk-Advance

SW4000 USER MANUAL - Nilfisk PARTS - Nilfisk-Advance

MEHR ANZEIGEN
WENIGER ANZEIGEN

Sie wollen auch ein ePaper? Erhöhen Sie die Reichweite Ihrer Titel.

YUMPU macht aus Druck-PDFs automatisch weboptimierte ePaper, die Google liebt.

<strong>USER</strong> <strong>MANUAL</strong>ENGLISHENGINE OIL LEVEL CHECKCAUTION!Running the engine with a low oil level candamage the engine itself.FNOTEThe oil alert system will automatically stop the enginebefore the oil level goes down under the safety limit.To avoid a sudden engine stop, always check the oillevel before each start-up.A1. Drive the machine on a level ground and engage theparking brake.2. Turn the ignition key (61) to “0”.3. Open the engine compartment hood (18) with the handle(41) and fasten it with the support rod (53).4. Lift and disassemble the right side bulkhead (45).5. Remove the oil filler plug/dipstick (A, Fig. 21) and clean it.6. Insert the oil filler plug/dipstick in the filler neck (B), but donot tighten it, then remove it to check the oil level.7. If the oil level is near or under the lower limit mark (C) onthe dipstick, top up with the specified oil up to the upperlimit mark (D) (lower edge of the oil filling hose). Do notoverfill.8. Install the oil filler plug/dipstick (A).EABDENGINE OIL CHANGECAUTION!The discharged engine oil must be disposed ofproperly according to the Law in force.NOTEIt is advisable to change the oil when the engine isstill hot, to make the oil downflow easier.1. Drive the machine on a level ground and engage theparking brake.2. Turn the ignition key (61) to “0”.3. Open the engine compartment hood (18) with the handle(41) and fasten it with the support rod (53).4. Lift and disassemble the right side bulkhead (45).5. Remove the oil filler plug/dipstick (A, Fig. 21), place thehose (E) in a position that eases the oil drain, then removethe plug (F).6. Remove the oil drain plug (F) from the hose and drain theoil into a suitable container, then install the oil drain plugand hose.7. Pour new oil in the filler neck (B) up to the upper limit mark(D) (lower edge of the oil filling hose) on the dipstick.NOTEAs for engine oil type and quantity, see the TechnicalData chapter and the Engine Manual.8. Install the oil filler plug/dipstick (A) and tighten it.CFigure 21P1006161464815000 - <strong>SW4000</strong> 31

Hurra! Ihre Datei wurde hochgeladen und ist bereit für die Veröffentlichung.

Erfolgreich gespeichert!

Leider ist etwas schief gelaufen!