SW4000 USER MANUAL - Nilfisk PARTS - Nilfisk-Advance

USER MANUALENGLISHDUSTGUARD SYSTEM WATER FILTER CLEANING (OPTIONAL)NOTETo prevent water from flowing out when cleaning thefilter, turn on the dust guard system and empty thesystem tank (24).1. Drive the machine on a level ground.2. Turn the ignition key (61) to “0” and engage the parkingbrake.3. From under the machine (A, Fig. 18), reach the water filterassembly (B) of the dust guard system.4. Unscrew and remove the transparent cover (C) with thegasket (D), then remove the filter strainer (E).5. Clean and install them on the holder (F).NOTEInstall the gasket (C) and the filter strainer (E) inthe housings of the cover and of the filter assemblyholder.AFDEBCFigure 18P100648HOPPER HYDRAULIC LIFTING SYSTEM OIL LEVEL CHECKWARNING!Procedure to be performed with the hopper (11)fully retracted.1. Turn the ignition key (61) to “0” and engage the parkingbrake.2. Open the engine compartment hood (18) with the handle(41) and fasten it with the support rod (53).3. Check that the oil level in the tank (52) is between theminimum (MIN) and maximum (MAX) marks shown infigure 19.4. If necessary, add oil through the plug (A, Fig. 19), using theoil specified in Technical Data paragraph.5. Remove the support rod (53) and close the hood (18).Figure 19P1006071464815000 - SW4000 29