SW4000 USER MANUAL - Nilfisk PARTS - Nilfisk-Advance

ENGLISHUSER MANUALSKIRT HEIGHT AND OPERATION CHECKPreliminary Operations1. Empty the hopper (as shown in Use chapter), because theweight of the waste inside the hopper can affect the skirtheight check.2. Drive the machine on a level ground that is suitable forchecking the skirt height.3. Turn the ignition key (61) to “0” and engage the parkingbrake.Side Skirt Check4. Remove the left and right doors (13 and 12) by turning thefasteners.5. Check the side skirts (A, Fig. 13) for integrity.Replace the skirts when they have cuts (C, Fig. 14) largerthan 20 mm or cracks/tears (D) larger than 10 mm (for skirtreplacement, refer to the Service Manual).6. Check that the distance from the floor of the side skirts (A,Fig. 13) is within 0 - 3 mm (Fig. 15).If necessary, loosen the knobs (B, Fig. 13) and adjust theskirt position. Then tighten the knobs (B).BFigure 13ACBP100602Front and Rear Skirt Check7. Remove the main broom as shown in the relevantparagraph.8. Check the front skirt (E, Fig. 16) and rear skirts (F) and (G)for integrity.Replace the skirts when they have cuts (C, Fig. 14) largerthan 20 mm or cracks/tears (D) larger than 10 mm.9. Check that the front (E, Fig. 16) and rear skirt (G) slightlyrub ground without being detached from it (Fig. 17).10. For the skirt replacement, see the Service Manual.Reassembly> 10 mm(> 0,4 in)DFigure 14> 20 mm(> 0,8 in)0÷3 mm(0÷0,12 in)P10060311. Assemble the components in the reverse order ofdisassembly.Figure 15P100604E F GFigure 16P100605Figure 17P10060628 SW4000 - 1464815000