POWER WAVE 345M C - Sveiseeksperten

Advantages:• Wider operating range, ability to weld thinnermaterials.• Less demanding in terms of wire placement, travelspeed and parameter adjustment.• High travel speed without lack of fill imperfections.• Good bead wetting, less undercut, flatter weld bead.• Good penetration profile. Less short circuitdisturbances. The High-Energy pulse cleans thebase metal and improves arc stability.• Pulse-on-Pulse provides "stacked dime" weld beadappearance making the weld more uniform inappearance.• Keep clean the machine. Use a soft dry cloth toclean the external case, especially the airflow inlet /outlet louvers.WARNINGDo not open this machine and do not introduce anythinginto its openings. Power supply must be disconnectedfrom the machine before each maintenance and service.After each repair, perform proper tests to ensure safety.MaintenanceWARNINGFor any maintenance or repair operations it isrecommended to contact the nearest technical servicecenter or Lincoln Electric. Maintenance or repairsperformed by unauthorized service centers or personnelwill null and void the manufacturers warranty.The frequency of the maintenance operations may varyin accordance with the working environment. Anynoticeable damage should be reported immediately.• Check cables and connections integrity. Replace, ifnecessary.Display CodeCode Description Corrective actionScrolling dash Appears at power up while the machine is going through its selfconfiguration."Err" "####" Fault code display. The first fault to occur will be displayed for threeseconds. The display will cycle through fault codes for all faults thatpersist after the initial three-second period are displayed for 1 secondeach."----" "----" Weld mode is changing."####" "####"(on steady)Machine output is on. Left display is current, right display is voltage.If actively welding, the displays are arc current and arc voltage. If not"####" "####"(blinking)"no" "H2O"actively welding, the display will show workpoint.Weld just finished – the average arc voltage and current will beblinked for 5 seconds following a weld. If the workpoint changesduring this 5 second period, the display will revert to the above mode.No Water. The water flow sensor has detected a water flow shutdown (