1:8 SCALE 4WD NITRO BUGGY TR8 CHASSIS - Absima

Transmitter PreparationPower SwitchAntenna27MHzTransmitter Crystal (TX)ONExtend the antenna to the maximumLength for best performanceTransmitter crystal(TX)Receiver crystal(RX)OFFThe crystal can be replaced to change frequencies.Note : You must also change receiver crystals!Do not use AM crystalsBattery Level IndicatorGood BatteriesLow Batteries(Light Blinks)Left turnStraight (neutral)Right turn1Steering Trim31Reverse Switch反 向 开 关Servo Factory SettingsDIGITALPROPORTIONALRADIO CONTROLSYSTEM2To be used for trimming the steeringoperation4Brake2Throttle TrimForwardStop(Neutral)DIGITALPROPORTIONALRADIO CONTROLSYSTEMTo be used for throttle operationThrottle TriggerTo be used for trimming the throttleoperation43ch Switch3Steering Dual RateThis switch is used for optional parts.To be used to adjust steering servo throwTransmitter Battery InstallationOpen battery cover at the bottom of transmitter.Install batteries. Follow the direction of batteriesdesignated in the inside of battery box.Battery Cover8XAA Alkaling Batteries