Bedienungsanleitung - in der support-zone

Select Installation from the main menu by pressing “” or “ ” buttons.highlight TXT Language. Select a region by using “ ”or “ ” button. When nished, press OK or RED buttonto continue. To cancel, press the BLUE button.Aerial InstallationSelect Aerial Installation line and use OK button toview the menu contents:Automatic Channel ScanAutomatic channel scan is started by pressingOK button while Automatic channel scan item ishighlighted. The following message appears on thescreen:Highlight Yes or No by using “ ” or “ ” buttonsand press OK button to con rm. If Yes is selected,automatic search starts. Selecting No cancelsautomatic search. After search is completed for digitalchannels, a message asking whether to search foranalogue channels appears on the screen:After APS is nalized, the programme table will appearon the screen. In the programme table you will seethe programme numbers and names assigned to theprogrammes.Channel SearchIn manual channel search, the number of the multiplexis entered manually and only that multiplex is searchedfor the channels. For every valid channel number,signal level and signal quality are shown on thescreen. In both channel and auto search any existingchannel in the database is not re-stored to avoidredundant duplicates of that channel.Frequency SearchEnter the desired frequency. When nished, press OKbutton, and the TV will start frequency search.Network SearchWhen you select Network Search line and press OKbutton, the following menu screen will be displayedon the screen:Highlight Yes and press OK button to search foranalogue channels. The following menu appears onthe screen for analogue channel search:Select YES to continue and Network Search screenwill be displayed. The process will then start.Set Language item by pressing “ ” or “ ” button.Press “ ” or “ ” button to highlight Country item andthen use “ ” or “ ” to set. Press “ ” or “ ” button toEnglish - 66 -During the Network Search, if channels that havenetwork search info are found, automatic searchprocess will end by locating those channels. Aftersearch is completed, a message asking whether tosearch for analogue channels appears on the screen.Operation of analogue channel installation is explainedin “Automatic Channel Scan” section above.