Finish 270 Finish 250 - Wagner

GBFinish 270 / 250Startup4.5 Cleaning preserving agent whenstarting-up of operation initiallyUnit with suction tube1. Immerse the suction system into a container filled with asuitable cleaning agent (recommendation: water).Unit with hopper2. fill up hopper with a suitable cleaning agent (recommendation:water).3. Switch on unit.4. Turn the pressure regulating knob (1) to the right untilthe stop is reached.5. Open relief valve (2)valve position (circulation)6. Wait until cleaning agent is emitted from the return hose.7. Turn the pressure regulating knob (1) back approx. onerotation.8. Close relief valve (2)valve position (spraying), pressure is rising up insidethe high pressure hose (visble at pressure gage)9. Point the tip of the spray gun into an open collecting containerand pull the trigger guard at the spray gun.10. The pressure is increased by turning the pressure regulatingknob (1) to the right. Set approx. 10 MPa at the pressuregage.11. Spray the cleaning agent out of the unit for approx.1 - 2 min. (~5 liters) into the open collecting container.4.6 Ventilate unit (hydraulic system) if thesound of inlet valve is not audible1. Switch on the unit.2. Turn pressure regulating knob (1) three revolutions tothe left.3. Open relief valve (2)valve position (circulation)The hydraulic system is ventilated. Leave the unit on fortwo or three minutes.4. Then turn pressure regulating knob (1) to the right untilstop.5. Press inlet valve pusher (4).Sound of the inlet valve is audible.6. If not, repeat points 2 and 443124.7 Taking the unit into operation withcoating materialUnit with suction tube1. Immerse the suction system into a container filled withcoating material.Unit with hopper2. fill coating material into the hopper.3. Press inlet valve pusher (4) several times to release possiblyclogged inlet valve4. Open relief valve (2)valve position (circulation)5. Switch on unit.6. Turn the pressure regulating knob (1) to the right untilthe stop is reached.When the noise of the valves changes, the unit is bled andtakes in coating material.7. If coating material exits from the return hose, turn thepressure regulating knob (1) back approx. 1 rotation.8. Close relief valve (2)valve position (spraying), pressure is rising up insidethe high pressure hose (visble at pressure gage)9. Pull of the spray gun and spray into an open collectingcontainer in order to remove the remaining cleaningagent from the unit. When coating materials exits fromthe tip, close the spray gun.10. Pull of the spray gun and adjust the spraying pressure byturning the pressure regulating knob (1).11. The unit is ready to spray.40