SMS 9941 NF / SMK 9941 F / SMK 9961 F / SMS 9401 NF ... - Spaun

• DiSEqC:
A mode selector for every receiver output (A...D/A...F/A...H) is present.
With this selector the reaction to 22 kHz tone and ToneBurst may be
swapped to change the sat-system with the 22 kHz tone. The switch
position swaps the satellite positions A and B. In this mode the
satellite B is the default satellite system. (Necessary for receivers without
position control signals.) To apply the mode a reset must be done (interruption
of receiver remote voltage or interruption of mains power or
DiSEqC command 'Reset'). In case of a connected non DiSEqC DVBreceiver
the selector must be in 'Band' mode!
Signal
14/18 V
0 kHz/22 kHz
ToneBurst A / ToneBurst B
DiSEqC
Selection
Band
Position
vertical/horizontal
vertical/horizontal
low-Band/high-Band SAT-System A/B
SAT-System A/B low-Band/high-Band
uneffected
The multiswitches support DiSEqC level 2.0. Bi-directional communication with the
receiver is possible.
The multiswitches can be controlled by every DiSEqC receiver (including DiSEqC 1.0).
The DiSEqC 'Standby' command is supported.
When the multiswitch receives a valid DiSEqC command all analogue control signals
will be ignored until a reset is done.
The DiSEqC address is 14Hex.
DiSEqC is implemented according to DiSEqC Bus Specification 4.2.
Assembly
Do not mount the multiswitches in damp conditions. Allow adequate
ventilation.
It is convenient to use the push-on F-connectors ZSV 2S when the
multiswitches are mounted vertically.
Dimensions
SMS 9401 NF:
SMS 9601 NF:
SMS 9801 NF:
SMS 9941 NF:
SMK 9941 F:
SMK 9961 F:
440x168x75 mm (WxHxD)
440x168x75 mm (WxHxD)
440x168x75 mm (WxHxD)
440x168x75 mm (WxHxD)
338x168x64 mm (WxHxD)
338x168x64 mm (WxHxD)
D
W
H
DiSEqC is a trademark of EUTELSAT.
Whilst every effort has been made to provide accurate information, no responsibility is accepted for errors or
omissions.