Bedienungsanleitungen

Instruction Manual LS 60 Plus page 23
________________________________________________________________________________________________________________
6. Troubleshooting
a.) The pressure ring (ram) comes to a standstill during a punching cycle.
=> Stop the punching cycle. Hold down the retract button and at the same time actuate
the trigger for around 10 seconds. If the malfunction can’t be eliminated the tool
has to be returned to the manufacturer.
b.) The tool is leaking oil.
=> Return the tool to the manufacturer. Do not open the tool or remove its seal.
c.) Error indicated by the light diode display (Pos.-No. 6)
Pls. see chapter 4.5 (Error indication)
7. Putting out of operation/waste disposal
After intensive use even a high-quality tool has to be put of operation.
The disposal of the various components of the tool have to be treated separately. Doing
that the first step is to dispose of the oil at special delivery points.
Attention
Hydraulic oils represent a danger for the ground-water. Uncontrolled
draining of or improper disposal is under penalty.
(environmental liability law)
Next, the battery cartridge has to be specially disposed of.
To dispose of the remaining parts of the unit please consult your national environmental
laws.
Because of possible environmental damages we recommend to dispose of the tool by
professional companies.
Attention
Do not dispose of the unit in your residential waste because it will finally end up
on the waste dump which would be hazardous for the environment.
A return of the old tool free of charge to the manufacturer cannot be granted.