Download (9Mb) - tuprints

[171] S. Shahpar and L. Lapworth. Padram: Parametric design and rapid meshing system for
turbomachinery optimisation. Proceedings of ASME Turbo Expo, (Paper number GT-2003-
38698), 2003.
[172] S. Shahpar. Soft: A new design and optimisation tool for turbomachinery. Evolutionary
Methods for Design, Optimisation and Control, pages 455–460, September 2002.
[173] I. Sobol. On the systematic search in a hypercube. SIAM Journal of Numerical Analysis,
16:790–793, October 1979. Issue 5.
[174] M. Buhmann. Radial Basis Functions: Theory and Implementations. Cambridge University
Press, 2003.
[175] D. Sasaki and S. Obayashi. Low-boom design optimization for sst canard-wing-fuselage
configuration. Proceedings of AIAA Computational Fluid Dynamics Conference, (Paper number
AIAA-2003-3432), 2003.
[176] C. Biela, C. Brandstetter, F. Holzinger, and H.-P. Schiffer. Influence of inlet guide vane wakes
on performance and stability of a transonic compressor. Proceedings of International
Symposium on Air Breathing Engines, (Paper number 2011-1209), 2011.
[177] H. Passrucker, J. Bergner, S. Kablitz, D. Hennecke, and E. Steinhardt. Influence of sweep
on the 3d shock structure in an axial compressor. Proceedings of ASME Turbo Expo, (Paper
number GT-2005-68835), 2005.
[178] C. Biela. Untersuchungen zum Einfluss des Vorleitrades auf die Strömung in einem anderthalbstufigen
Axialverdichter. PhD thesis, TU Darmstadt, 2012.
[179] D. Bruna and M. G. Turner. Isothermal boundary condition at casing applied to the rotor
37 transonic axial flow compressor. ASME Journal of Turbomachinery, 135(Paper number
034501), May 2013. Issue 3.
[180] J. Städing, D. Wulff, G. Kosyna, B. Becker, and V. Gümmer. An experimental investigation
of stator clocking effects in a two-stage low-speed axial compressor. Proceedings of ASME
Turbo Expo, (Paper number GT-2011-45680), 2011.
[181] N Harvey, M. Rose, M. Taylor, S. Shahpar, J. Hartland, and D. Gregory-Smith. Nonaxisymmetric
turbine end wall design: Part 1 three-dimensional linear design system. ASME
Journal of Turbomachinery, 122:278–285, April 2000. Issue 2.
[182] J. Hartland and D. Gregory-Smith. A design method for the profiling of end walls in
turbines. Proceedings of ASME Turbo Expo, (Paper number GT-2002-30433), 2002.
[183] D. Gregory-Smith, D. Bagshaw, G. Ingram, and M. Stokes. Using profiled endwalls, blade
lean and leading edge extensions to minimise secondary flow. Proceedings of ASME Turbo
Expo, (Paper number GT-2008-50811), 2008.
[184] J. Hartland, D. Gregory-Smith, N. Harvey, and M. Rose. Nonaxisymmetric turbine end
wall design: Part 2 experimental validation. ASME Journal of Turbomachinery, 122:286–
293, April 2000. Issue 2.
Literaturverzeichnis 111