Montageanleitung Assembly instructions ... - Villeroy & Boch

Sauna stove/Comfort Climate stove 3kW
4. Set up stove
4.1. Set up wall-type stove
FIRE HAZARD! Never operate the stove without first filling it with stones.
Do not leave bags of aromatic herbs lying on the vaporizer of the Comfort Climate stove.
1. Unpack the stove and set it up on the floor.
. If the stove is installed in a corner, observe the
minimum wall-element clearance of 50 mm - See
fig. 4.1.
2. Mark and drill fixing holes in the wall element
(ø 2.5 mm).
3. Insert the fixing screws (5 x 35 mm) into the wall
element.
4. Attach the stove to the fixing screws.
5. Insert the locking screw into the clip on the
stove.
6. Plug the stove connection cable into the socket
on the heating device.
. Carefully fill the container with stones, taking care
not to damage the heating elements when doing
so.
Temperature-
Sensor + STL
Centre
Stove installation height
OK FFB 685 mm
285 mm
Stove
Inside view
Electric wall element
Fixing screws
Panhead 5x35
Fig. 4
K0020_3
Fig. 4.1
Applies only to Comfort Climate stove:
1. Fit the washer to the drain tap.
2. Screw the drain tap to the drainpipe on the
underside of the stove.
Filling with stones
Fig. 5
K0260_1
5. Operating the unit for the first time
Fire and burn-injury hazard
Never operate the stove without first filling it with stones.
A slight smell may be apparent the first time the cabin is heated up. This is due to the
initial use of the heating elements.
5080118/10.05
PAGE 15