Installation Instructions - DEHN (UK)
Installation Instructions - DEHN (UK)
Installation Instructions - DEHN (UK)
Erfolgreiche ePaper selbst erstellen
Machen Sie aus Ihren PDF Publikationen ein blätterbares Flipbook mit unserer einzigartigen Google optimierten e-Paper Software.
<strong>Installation</strong> step<br />
1<br />
At first, the tube support is inserted into the basic support (see Fig. 3).<br />
Then, the right cross rod is led through both holes of the basic support and through the inserted tube<br />
support.<br />
All locking screws must be screwed down (see Fig. 3).<br />
The cross rods may also be turned in case the rafter holder is installed from the bottom.<br />
tube support<br />
2<br />
1<br />
M8 locking<br />
screws/tube<br />
support<br />
1<br />
1<br />
2<br />
1<br />
2<br />
2<br />
M8 locking<br />
screws/basic<br />
support<br />
basic support<br />
right cross rod<br />
Fig.<br />
3<br />
Two different adjustable hinges (hole spacing of 57 mm or 85 mm) are available to position the tube<br />
support at a right angle. Depending on the roof inclination (from 24° to 53°) the relevant adjustable<br />
hinge must be screwed into one of the four holes of the position holder of the basic support.<br />
The other end of the adjustable hinge is screwed into the sliding guide of the tube support (fine adjustment<br />
via long hole) (see Fig. 4).<br />
2 adjustable hinges<br />
for roof inclination from<br />
36° - 53°<br />
Assembly of the rafter holder<br />
position holder<br />
adjustable hinge<br />
2<br />
basic support<br />
adjustable range from 60 to 75 cm<br />
1<br />
tube support<br />
sliding guide<br />
1<br />
1<br />
locking screws/<br />
tube support<br />
for roof inclination from<br />
24° - 41°<br />
2<br />
2<br />
2<br />
locking screws/<br />
basic support<br />
Fig.<br />
4<br />
Tube support with sliding guide<br />
Page 4<br />
1759_MO_0811_DE_GB_059294
Change language