Einbauanleitung
Einbauanleitung
Einbauanleitung
Erfolgreiche ePaper selbst erstellen
Machen Sie aus Ihren PDF Publikationen ein blätterbares Flipbook mit unserer einzigartigen Google optimierten e-Paper Software.
After aligning the air-termination rod/air-termination tip, the aluminium roof tile must be fitted in<br />
place as follows:<br />
1. Before installing the aluminium roof tile, check the surfaces of the adjoining roof tiles to which<br />
the aluminium tile is to be adhered. These surfaces must be clean, dry as well as free of dust,<br />
grease and moss. Observe a temperature range of +5°C to +40°C!<br />
2. Position the air-termination rod/air-termination tip in the centre of the roofing so that the<br />
aluminium roof tile completely covers the original roof tile over the entire surface.<br />
The air-termination rod/air-termination tip must not contact any point of the hole in the<br />
aluminium roof tile. No pressure or stress must be applied to the aluminium roof tile. Compared<br />
with a lead tile (which is only loosely installed (“floating”)), the aluminium roof tile is firmly<br />
attached to the roof by butyl adhesive strips.<br />
Due to its centred position, the air-termination rod/air-termination tip has enough space for<br />
“swinging”. If this space is not provided, the aluminium roof tile may become leaky in the<br />
course of time (see Fig. 9 and 10, page 12).<br />
centred position<br />
Fig. 9<br />
correct<br />
bottom position<br />
3. Remove the three adhesive protection strips from the aluminium roof tile and firmly press it on<br />
the adjoining roof tiles. The adhesive on the aluminium roof tile is vulcanised by solar radiation<br />
and will gradually harden (see Fig. 10 and Fig. 11, page 12).<br />
Note:<br />
If the surface to which the aluminium roof tile is adhered is not clean enough, the adhesive<br />
strips will not properly stick to the surface. In this case, it is advisable to use replacement<br />
adhesive strips.<br />
The aluminium roof tile must be flanged underneath the roof tiles situated above to ensure that<br />
rain water (driving rain) does not to penetrate underneath the roofing.<br />
Moreover, the aluminium roof tile must overlap the roof tile on the right side and the roof tiles<br />
underneath it.<br />
The aluminium roof tile must be flanged to these roof tiles in a plane way (see Fig. 10 and<br />
Fig. 11, page 12).<br />
11<br />
incorrect top position<br />
incorrect