UVA 97033 UVC 97034 - Henkel
UVA 97033 UVC 97034 - Henkel UVA 97033 UVC 97034 - Henkel
16 2 Description 2.5 Working in the Menu The graph shows the structure of the menu. To get to the specific menu options, push the illuminated button pointing to the corresponding menu option, in this example: MENU. Several buttons may be illuminated at the same time, e.g. menu options UP and DOWN. Step-by-step setup instructions are provided in the sections relating to the specific menu options (sections 4.7, 4.8, 4.9, 4.10, 5.1 and 5.2). 3 Technical Data Power supply: 110 – 240 VAC ±10%, 50 – 60 Hz Power consumption: Max. 380VA Current consumption max. 3.3 A Power protection Glass tube, fine wire fuse 5 x 20 mm 3.15 A, slow-blow (2 pcs) Lamp Power Stabilization Better than 1% Lamp Type 200 W superpressure mercury arc DC lamp Lamp Life Approx. 1500 – 2000 hours Internal control voltage 24 VDC Warm-up time of UV lamp 180 s Dimensions (width x height x depth): 340 mm * 160 mm * 310 mm 13.4” * 6.3” * 12.2” Weight: ~ 7.5 kg UV Lamp Operating temperature +10°C - +35°C (+50°F - +95°F) Storage temperature -10°C - +60°C (+14°F - +140°F) Light guides Storage and Operation temperature +5°C - +30°C (+41°F - +86°F) Minimum Bend Radius Light guide Ø5 mm: 80 mm (3”) Light guide Ø8 mm: 120 mm (4.8”) Light guide 2*Ø3 mm: 60 mm (2.5”)
4 Installation 4.1 Environmental and Operating Conditions The equipment should be installed in a dry, dust-free place. Make sure to install the equipment in a place permitting free access of cooling air to the bottom and to the back of the UV Wand System. 4.2 Space Requirements 4.3 Lamp Module Assembly (Lamp Replacement) 97034 340 mm (13.4 inch) The changing of the lamp-module should be done only after the lamp has completely cooled off. • Disconnect the power cord. • Remove the top cover of the unit by unscrewing the two upper screws on the left and right hand side of the unit respectively. • Disconnect earth cable. Avoid touching and contaminating the lamp inside the module. 160 mm (6.3 inch) 100 - 150 mm (4 - 6 inch) Space for Ventilation 310 mm (12.2 inch) Any contamination, which has not been removed, will bake to the envelope and result in premature deterioration of performance. 17
- Seite 1 und 2: Operating Manual Bedienungsanleitun
- Seite 3 und 4: Contents 1 Please observe the follo
- Seite 5 und 6: 1 Please observe the following For
- Seite 7 und 8: 1 Please observe the following Tran
- Seite 9 und 10: 1 Please observe the following Repa
- Seite 11 und 12: 2 Description UV minimum threshold
- Seite 13 und 14: 2 Description 2.2.1 UV Wand System
- Seite 15: 2 Description 2.4 Structure of the
- Seite 19 und 20: 4 Installation 4.4 Lamp Module Disa
- Seite 21 und 22: 4 Installation 4.7 Switching the Un
- Seite 23 und 24: 4 Installation 4.9 Adjusting the UV
- Seite 25 und 26: 4 Installation 4.11 Handling of the
- Seite 27 und 28: 5 Curing • Press ON button to swi
- Seite 29 und 30: 6 Protective Devices 6.1 Safety Swi
- Seite 31 und 32: 8 Troubleshooting Whenever this err
- Seite 33 und 34: 9 Annex 9.2 Pin Connection 9.2.1 XS
- Seite 35 und 36: Inhaltsverzeichnis 1 Bitte beachten
- Seite 37 und 38: 1 Bitte beachten Sie Für den gefah
- Seite 39 und 40: 1 Bitte beachten Sie Transportsiche
- Seite 41 und 42: 1 Bitte beachten Sie Reparaturen un
- Seite 43 und 44: 2 Gerätebeschreibung Nach einem La
- Seite 45 und 46: 2 Gerätebeschreibung 2.2.1 UV Syst
- Seite 47 und 48: 2 Gerätebeschreibung 2.4 Struktur
- Seite 49 und 50: 4 Installieren 4.1 Umgebungs- und B
- Seite 51 und 52: 4 Installieren 4.4 Ausbau Lampenmod
- Seite 53 und 54: 4 Installieren 4.7 Einschalten des
- Seite 55 und 56: 4 Installieren 4.9 Kalibrieren des
- Seite 57 und 58: 4 Installieren 4.11 Handhabung des
- Seite 59 und 60: 5 Aushärten von Klebstoffen • Dr
- Seite 61 und 62: 6 Sicherheitseinrichtungen 6.1 Sich
- Seite 63 und 64: 8 Fehlersuche Bei Erscheinen dieser
- Seite 65 und 66: 9 Anhang 9.2 Steckerbelegung 9.2.1
16<br />
2 Description<br />
2.5 Working in the Menu<br />
The graph shows the structure of the menu.<br />
To get to the specific menu options, push<br />
the illuminated button pointing to the<br />
corresponding menu option, in this<br />
example: MENU.<br />
Several buttons may be illuminated at the<br />
same time, e.g. menu options UP and<br />
DOWN.<br />
Step-by-step setup instructions are provided in the sections relating to the specific menu<br />
options (sections 4.7, 4.8, 4.9, 4.10, 5.1 and 5.2).<br />
3 Technical Data<br />
Power supply: 110 – 240 VAC ±10%, 50 – 60 Hz<br />
Power consumption: Max. 380VA<br />
Current consumption max. 3.3 A<br />
Power protection Glass tube, fine wire fuse 5 x 20 mm 3.15 A,<br />
slow-blow (2 pcs)<br />
Lamp Power Stabilization Better than 1%<br />
Lamp Type 200 W superpressure mercury arc DC lamp<br />
Lamp Life Approx. 1500 – 2000 hours<br />
Internal control voltage 24 VDC<br />
Warm-up time of UV lamp 180 s<br />
Dimensions (width x height x depth): 340 mm * 160 mm * 310 mm<br />
13.4” * 6.3” * 12.2”<br />
Weight: ~ 7.5 kg<br />
UV Lamp<br />
Operating temperature<br />
+10°C - +35°C (+50°F - +95°F)<br />
Storage temperature -10°C - +60°C (+14°F - +140°F)<br />
Light guides<br />
Storage and Operation temperature<br />
+5°C - +30°C (+41°F - +86°F)<br />
Minimum Bend Radius Light guide Ø5 mm: 80 mm (3”)<br />
Light guide Ø8 mm: 120 mm (4.8”)<br />
Light guide 2*Ø3 mm: 60 mm (2.5”)