Gebruikstechniek - Uzin Utz AG

System carbide milling wheel disc, Item-No. 526430:
for removing adhesives, PU- and epoxy-coatings and roughening anhydrite pavements („beating“ action) Due
to the aggressive action, the system milling discs should not be used onto chip board.
Milling disc with star wheel segments, Item-No. 526400
Additional to the new System-milling-disc the milling disc with star wheel segments offers high efficiency.
Producing a high effect of dismounting and an aggressive action, this disc is used for removing coatings and
adhesive residues. The result is a rough surface. Comes with 4 star wheel segments.
Cleaning pad discs 400 mm, 10 mm
For initial cleaning, Item-No. 525950, For cleaning and mounting of gauze
For maintenance, Item-No. 525960, For coarse cleaning and removing soil
For polishing, Item-No. 525970, For polishing, cleaning and wax coating
Super pad discs 400 mm, 20 mm
For initial cleaning, Item-No. 525981, For cleaning strong soiling
For maintenance, Item-No. 525982, For coarse cleaning and removing soil
For polishing, Item-No. 525983, For polishing, cleaning and wax coating
7.0 Trouble shooting
Trouble Eventual cause Elimination
Machine does not Power supply Have machine
start Disconnected repaired by a qualified
blown fuse electrician,
defective cable or plug resp. change parts
Assembly of handle wrong Assemble handle like
described in Item 5.0
Switch-on lever (4) Safety lever (4) can only be Lower the handle of
cannot be actuated actuated, if handle not vertical the machine
07/2003 Fugenfräse FRÄSMASTER
16