G&D DVICenter - Guntermann und Drunck GmbH
G&D DVICenter - Guntermann und Drunck GmbH
G&D DVICenter - Guntermann und Drunck GmbH
Erfolgreiche ePaper selbst erstellen
Machen Sie aus Ihren PDF Publikationen ein blätterbares Flipbook mit unserer einzigartigen Google optimierten e-Paper Software.
Connecting the second central module<br />
Target module »DVI-DP-CPU-UC«<br />
Trans. 2: Connect this interface to a Dynamic Port of the second central module that is<br />
configured to connect target modules.<br />
NOTE: Note the instructions in the paragraph Connecting target modules to the central<br />
module provided in the installation guide of the matrix switch.<br />
NOTE: You can establish a direct connection between a target and a user module.<br />
Use a category 5e (or better) crossover cable to connect the modules.<br />
Power supply<br />
Power In: Insert the power pack’s connection cable to this interface.<br />
Connect the power cable to the power pack and a power socket.<br />
Status displays<br />
The LED on the back panel of the target module inform you about the status of the<br />
external power pack:<br />
LED Status Meaning<br />
Power on The external power pack is connected and the required voltage (12 Volt)<br />
is available.<br />
off The external power pack is not (properly) connected.<br />
The flashing Transmission LEDs highlight the following operating statuses of the<br />
particular connection:<br />
LED Status Meaning<br />
Yellow Off No user module accesses the target module.<br />
On A user module accesses the target module.<br />
Blinking The incoming video signal was not detected.<br />
Flashing No voltage at PS/2 interface or USB bus.<br />
Green Off The target module is turned off.<br />
Blinking The power pack is connected and supplies the required power.<br />
The connection to the central module could not be established.<br />
Flashing The connection to the central module is established.<br />
No user module is accessing or the computer is turned off.<br />
On A user module accesses the target module.<br />
A computer is connected and turned on.<br />
Flickering Keyboard and mouse inputs are transmitted by the accessing user module.<br />
The flickering is defined by the user’s inputs.<br />
G&D <strong>DVICenter</strong> · 28