G&D DVICenter - Guntermann und Drunck GmbH

User module »U2-R-CON«
Installation
Connecting the console devices
RS232: Connect the serial end device to this interface.
Trans.: Use a category 5e (or better) twisted pair cable to connect this interface to the
Dynamic Port of the USB/RS232 Main Channel that is assigned to the console.
ADVICE: You can establish a direct connection between a target and a user module of
the network fails or a port at the central module does not work properly.
Use a category 5e (or better) crossover cable to connect both modules.
USB 2.0 Devices: Connect up to 4 USB devices to these interfaces.
Power In: Connect the power cable to the power pack and a power outlet.
Status displays
The blinking Transmission LEDs show the following connection statuses:
LED Colour Status Meaning
Left Yellow Off No connection to network.
63 · G&D DVICenter
On A user module is accessing the target module.
Right Green On A user module is accessing the target module.
Blinking No communication with central module.
Flashing Connection to central module established successfully.
No user module is accessing.