G&D DVICenter - Guntermann und Drunck GmbH
G&D DVICenter - Guntermann und Drunck GmbH G&D DVICenter - Guntermann und Drunck GmbH
User module »DVI-CON-12V« Power supply Main Power: Connect the power cable of a compatible power pack to this interface. Red. Power: To establish a redundant power supply, connect the power cable of another compatible power pack to this interface. LED Out: If you expanded the functional range of the matrix switch by purchasing the TradeSwitch function, connect the optional TS-LED-2 (order number A6100041) to this interface. Status displays Front panel The LEDs at the front panel of the user module inform you about the system’s operating status. Section LED Status Meaning Power Red. on The optional power pack is connected and the required voltage (12 Volt) is available. off The optional power pack is not (properly) connected. Main on The main power supply provides the required voltage. off The power pack is not (properly) connected. Status Trans. on The communication with the central module was established successfully. 59 · G&D DVICenter off The communication with the central module could not be established. System on The device boots or carries out a firmware update. blinking The system is ready for operation. Console Video on Stable image signal at video input. off The incoming video signal could not be detected or lacks the required quality to be processed by the system. K/M on A local keyboard was found. off No power at PS/2 interface or USB bus. blinking Power Status Console Red. Main Trans. System The CPU input (PS/2 or USB) is active and ready. No local keyboard was found. Video K/M Service
Back panel Transmission User module »DVI-CON-12V« The Transmission interface at the back panel of the user module provides additional status LEDs, which have the following functions: LED Colour Status Meaning left yellow off No connection to the network. TradeSwitch-LED The optional TS-LED (order number A6100041) lights if the keyboard and mouse signals of a master console are accessing the user module. Technical data blinking Network connection to an end device. right green on A user module is accessing the target module. blinking No communication with the central module. flashing Connection to central module established. No user module is accessing. flickering Keyboard and mouse inputs are forwarded by the accessing user module. The flickering is defined by the user’s entries. yellow flashing A firmware update is carried out. NOTE: The keyboard and mouse signals can only access another user module or a target computer if you purchased the TradeSwitch function for the central module. DVI-CON-12V Interfaces to console: Data transmission to central module LED Out Mouse DVI/VGA Out Micro In Speaker Keyb./Mouse Keyb. Red. Power Main Power Video: 1 × DVI-I (DVI Single-Link or VGA) Keyboard and mouse signals: 2 × PS/2 socket 2 × USB-A Audio: 2 × 3.5 mm jack socket Tradeswitch LED: 1 × D-SUB 9 socket Interface: 1 × RJ45 socket Transmission length: Max. 140 meters G&D DVICenter · 60
- Seite 79 und 80: Target module »DVI-CPU-UC« NOTE:
- Seite 81 und 82: Target module »DVI-CPU-MC2« Targe
- Seite 83 und 84: Connection to the central module Ta
- Seite 85 und 86: Technical data DVI-CPU-MC2 Interfac
- Seite 87 und 88: Installation Connecting the target
- Seite 89 und 90: Target module »DVI-CPU-MC2-UC« Au
- Seite 91 und 92: Technical data DVI-CPU-MC2-UC Inter
- Seite 93 und 94: Installation Connecting the target
- Seite 95 und 96: Status displays Target module »DVI
- Seite 97 und 98: Target module »DVI-DP-CPU-UC« Tar
- Seite 99 und 100: Connecting the second central modul
- Seite 101 und 102: Target module »U2-R-CPU« Target m
- Seite 103 und 104: Technical data U2-R-CPU Target modu
- Seite 105 und 106: Installation Connecting console dev
- Seite 107 und 108: Back panel User module »DVI-CON«
- Seite 109 und 110: User module »DVI-CON-MC2« User mo
- Seite 111 und 112: Power supply Main Power: Connect
- Seite 113 und 114: Back panel User module »DVI-CON-MC
- Seite 115 und 116: User module »DVI-CON-MC4« User mo
- Seite 117 und 118: Connection to the central module U
- Seite 119 und 120: Status displays Front panel Secti
- Seite 121 und 122: TradeSwitch-LED The optionally avai
- Seite 123 und 124: User module »DVI-CON-Video« User
- Seite 125 und 126: Start-up User module »DVI-CON-Vide
- Seite 127 und 128: Technical data DVI-CON-VIDEO Interf
- Seite 129: Installation Transmission LED Out C
- Seite 133 und 134: User module »U2-R-CON« User modul
- Seite 135 und 136: Technical data U2-R-CON User module
- Seite 137 und 138: NOTES
- Seite 139 und 140: NOTES
Back panel<br />
Transmission<br />
User module »DVI-CON-12V«<br />
The Transmission interface at the back panel of the user module provides additional<br />
status LEDs, which have the following functions:<br />
LED Colour Status Meaning<br />
left yellow off No connection to the network.<br />
TradeSwitch-LED<br />
The optional TS-LED (order number A6100041) lights if the keyboard<br />
and mouse signals of a master console are accessing the user<br />
module.<br />
Technical data<br />
blinking Network connection to an end device.<br />
right green on A user module is accessing the target module.<br />
blinking No communication with the central module.<br />
flashing Connection to central module established.<br />
No user module is accessing.<br />
flickering Keyboard and mouse inputs are forwarded by the accessing<br />
user module.<br />
The flickering is defined by the user’s entries.<br />
yellow flashing A firmware update is carried out.<br />
NOTE: The keyboard and mouse signals can only access another user module or a<br />
target computer if you purchased the TradeSwitch function for the central module.<br />
DVI-CON-12V<br />
Interfaces to<br />
console:<br />
Data transmission to<br />
central module<br />
LED Out<br />
Mouse<br />
DVI/VGA Out Micro In Speaker Keyb./Mouse Keyb. Red. Power<br />
Main Power<br />
Video: 1 × DVI-I (DVI Single-Link or VGA)<br />
Keyboard and mouse signals: 2 × PS/2 socket<br />
2 × USB-A<br />
Audio: 2 × 3.5 mm jack socket<br />
Tradeswitch LED: 1 × D-SUB 9 socket<br />
Interface: 1 × RJ45 socket<br />
Transmission length: Max. 140 meters<br />
G&D <strong>DVICenter</strong> · 60