G&D DVICenter - Guntermann und Drunck GmbH

Start-up
User module »DVI-CON-Video«
Start the user module by pressing the Main Power button of the power pack.
ADVICE: The active hotkey configuration is displayed during the System Startup of
the user module.
Status displays
Front panel
Power Status Console
Trans.
System
The LEDs on the front panel of the user module inform you about the system’s
operating status.
Section LED Status Meaning
Power Red. On The optional power pack is connected and the required voltage
(12 Volt) is available.
Off The optional power pack is not (properly) connected.
Main On The main power supply provides the required voltage.
Off The power button is turned off or the connection with the mains
could not be established.
Check the proper connection of the power supply cable.
Status Trans. On The communication with the matrix switch could be established.
Off The communication with the matrix switch could not be established.
System On The device is booting or carries out a firmware update.
Blinking
The system is ready for operation.
Console Video On Stable image signal at video input.
Off The incoming video signal could not be detected or it lacks the
required quality to be processed by the system.
Active On A local keyboard was found.
Off No power at PS/2 interface or USB bus.
Blink- The CPU input (PS/2 or USB) is active and ready.
ing No local keyboard was found.
Red.
Main
Video
K/M
Service
G&D DVICenter · 54