agc-4-parameter-list-4189340688-uk

5. Utility software settings
The utility software includes settings that do not have parameter numbers. This chapter gives a brief overview of these settings.
5.1 Application supervision
Access the Application supervision page from the left menu. You can change some parameters from here.
5.1.1 Plant settings
In Application supervision, access the plant settings from the icon on the top bar:
values of some parameters.
. In the Plant settings box you can change the
Figure 5.1
Example of Plant settings box
Changing the Genset mode in the example changes parameter 6070. Similarly, changing parameter 6070 changes the selection
shown in Plant settings.
5.2 Advanced protection
Access the Advanced protection page from the left menu. Advanced protection includes:
Capability curve
This includes the following outdated parameters: 1741, 7142, 7143, 1744, 1745, 1746, 1751, 1752, 1753, 1754, 1755, 1756, 1766,
1771, 1772, 1773, 1774, 1775, 1776, 1781, 1782, 1783, 1784, 1785, 1786, 1796.
You can also configure the capability curve from the TDU 107.
PARAMETER LIST 4189340688R EN Page 219 of 222