agc-4-parameter-list-4189340688-uk

2700 Reactive power control relay (requires option D1)
No. Setting Range Factory
setting
Description
2701 Q control Q dead band 0.0 to 10.0 % 2.0 % PI controller for reactive power
control. The reactive power
control is used for power factor
as well as reactive power
control.
2702 Q control Q Kp 0 to 100 10
These parameters are only
applicable if Relay is selected
in parameter 2783.
2710 Reactive power load sharing control relay (requires option D1)
No. Setting Range Factory
setting
Description
2711 Q load share
ctrl
2712
2713
2714
Q load share
ctrl
Q load share
ctrl
Q load share
ctrl
U dead band
U Kp
Q dead band
0.0 to 10.0 %
0 to 100
0.0 to 10.0 %
1.0 %
10
2.0 %
The VAr (Q) load sharing is
based on a mix of voltage and
VAr control. Parameter 2664 is
setting the impact of the VAr
controller over the voltage
controller.
Q weight 0.0 to 100.0 % 10.0 %
These parameters are only
applicable if Relay is selected
in parameter 2783.
2720 Relay control setup (AVR) (requires option D1)
No. Setting Range Factory
setting
Description
2721 Relay control AVR ON time t N 10 to 3000 ms 100 ms Relay outputs for voltage/ VAr/
2722 Relay control AVR period time t P 50 to 15000 ms 500 ms
power factor control.
2723 Relay control
2724 Relay control
Relay output A (U
increase)
Relay output B (U
decrease)
Not used (option
dependent)
Not used (option
dependent)
Not used
Not used
These parameters are only
applicable if Relay is selected
in parameter 2783.
2740 Delay regulation
No. Setting Range Factory
setting
Description
2741 Delay reg. Timer 0 to 9900 s 3 s Delay of activating regulation
after running feedback has
Not used (option
2742 Delay reg. Relay output A
Not used been detected.
dependent)
2743 Delay reg. Relay output B
2744 Delay reg. Enable
Not used (option
dependent)
OFF
ON
Not used
OFF
PARAMETER LIST 4189340688R EN Page 200 of 222