agc-4-parameter-list-4189340688-uk

2650 Reactive power control analogue (requires option D1)
No. Setting Range Factory
setting
Description
2651
2652
Q control
Q control
Q Kp
Q Ti
0.00 to 60.00
0.00 to 60.00 s
2.50
1.50 s
PID controller for reactive
power control. The reactive
power control is used for power
factor as well as reactive power
control.
2653 Q control Q Td 0.00 to 2.00 s 0.00 s
These parameters are only
applicable if Analogue or EIC is
selected in parameter 2783.
2660 Reactive power load sharing control analogue (requires option D1)
No. Setting Range Factory
setting
Description
2661 Q load share
ctrl
2662
2663
2664
Q load share
ctrl
Q load share
ctrl
Q load share
ctrl
Q LS Kp
Q LS Ti
Q LS Td
0.00 to 60.00
0.00 to 60.00 s
0.00 to 2.00 s
2.50
1.50 s
0.00 s
The VAr (Q) load sharing is
based on a mix of voltage and
VAr control. Parameter 2664 is
setting the impact of the VAr
controller over the voltage
controller.
Q weight 0.0 to 100.0 % 10.0 %
These parameters are only
applicable if Analogue or EIC is
selected in parameter 2783.
2670 Analogue AVR output offset (requires option D1)
No. Setting Range Factory
setting
Description
2671 Analogue
AVR
2672
2673
2674
Analogue
AVR
Analogue
AVR
Analogue
AVR
Offset 0 to 100 % 50.0 % Sets the offset of the analogue
output when starting the
generator.
Offset 0 to 100 % 50.0 %
Offset 0 to 100 % 50.0 %
Offset 0 to 100 % 50.0 %
These parameters are only
applicable if Analogue or EIC is
selected in parameter 2783.
2690 Voltage control relay (requires option D1)
No. Setting Range Factory
setting
Description
2691 U control U dead band 0.0 to 10.0 % 2.0 % PI controller for voltage control.
2692 U control U Kp 0 to 100 10
These parameters are only
applicable if Relay is selected
in parameter 2783.
2693 U droop relay Droop setting 0 to 10 % 0 %
The droop setting will be
applied on top of the regulation
output.
PARAMETER LIST 4189340688R EN Page 199 of 222