agc-4-parameter-list-4189340688-uk

9070 M4 software version
No.
Description
9070 Shows the M4 software version.
9071 Shows the M4 protocol version.
9072 Shows the M4 software revision.
9073 Shows the internal protocol version.
3.9.6 Device type
9100 Device type
No. Setting Range Factory
setting
Description
9100 Device Type DG controller
Mains controller*
BTB controller**
Genset Grp. Tie
controller***
Plant controller***
DG controller
This setting is only accessible
using the JUMP button on the
display.
*Note: A mains controller requires option G5.
**Note: A BTB controller requires option G4 or G5.
***Note: Requires option G7.
CAUTION
The AGC returns to the factory settings when the selection in parameter 9100 is changed.
3.9.7 Password
These parameters can also be configured from the utility software.
911x Password
No. Setting Range Factory
setting
Description
9116 Customer
Password
9117
9118
Service
Password
Master
Password
Setting
Setting
Setting
0 to 32000
0 to 32000
0 to 32000
2000
2001
2002
It is recommended to change
the password levels of the
user, service and master
password if access to
parameter settings must be
restricted.
3.9.8 Service menu
This menu shows the different timer values, the digital in- and outputs, and the status of the different lines in M-Logic.
9120 Service menu
No.
Description
9121 Shows the values of differential timers.
9123 Shows the status of the digital inputs of the unit.
PARAMETER LIST 4189340688R EN Page 187 of 222