Viktige anvisninger for korrekt håndtering - Atika

Operational faults
Before each fault elimination:
− Switch off device.
− Wait for standstill of the device.
− Pull out mains plug.
Fault Possible cause Remedy
Motor does not start
Motor hums but does not start
Shredding material is not drawn
into the shredder
No power supply Check fuses
Mains cable defective have these checked (electrician)
Machine overloaded/blocked and automatically
cuts out after 5 seconds reversing.
Retaining basket unlocked
(safety cut-out device of the retaining
basket has tripped)
Blade shaft blocked even after several
reversing tries.
To restart press the infeed switch
Lock the retaining basket
1. Loosen the adjusting knob (J).
2. Press the reversing switch .
Capacitor faulty Bring machine to manufacturer or authorised workshop
for repair
The cutting roller is running in reverse.
Wrong switch position
Shredding material caught in funnel
Switch off device and switch over direction of rotation
selector switch.
Press the infeed switch .
Shredding material too soft or wet Push down with a branch and shred
Cutting roller worn Adjust fixed counter blade as described under „adjusting
the fixed counter blade“. In case of severe
wear, replace cutting roller.
Shredding material not cut cleanly. Fixed counter blade not adequately
adjusted.
Device starts but blocks under as
slight load and switches off via
protective motor switch.
Extension cable too long or crosssection
to small.
Socket too far from mains supply and
cross-section of mains cable too small.
Adjust fixed counter blade.
Extension cable at least 1.5 mm², maximum 25 m
long. If a longer cable is used, minimum crosssection
2.5 mm².
17