Руководство по установке QSK HK

Preconditions
Expert knowledge
The electrical installations must be performed according to the current
national installation regulations as well as according to the regulations
of your local electric power utility company. These instructions require
special knowledge corresponding to an officially acknowledged degree
in one of the following professions:
Electrical Equipment Installer or Electronics Engineer
Systems Mechanic for sanitary, heating and air condition technology
according to the profession designations officially announced in the Federal
Republic of Germany, as well as according to comparable professions
within the European Community Law.
For the preparation of the manual, a state of knowledge corresponding
to a technician qualification in the mentioned occupational areas, has
been presupposed. Therefore, basic information from these occupational
areas is not described separately.
Installation place
Möhlenhoff QSK HK are exclusively intended for a horizontal installation
in floor areas. Möhlenhoff QSK HK can be installed in dry screed and cast
plaster areas as well as in cavity floors.
If used in areas with mastic asphalt, special measures have to be taken
with respect to temperature shielding, because no part of the QSK HK
may become warmer than 120 °C! In case of installation of the QSK
HK with blow-out direction towards the room, the connections will be
arranged as follows (view of direction towards the window): hydraulic -
left side; electric - right side.
41
Installation situation
1 Permanently elastic sealing
2 Border acoustic insulation by means of circumferential insulation strips
3 Step-on acoustic insulation
Screeds and floor coverings, parquet flooring in particular, may apply
pressure to the trough of a trench heater due to their thermal
behaviour. Therefore we recommend you to provide correspondingly
dimensioned expansion joints on site.
124645.1223 QSK HK 260 | 320 | 360
DEU
ENG
RUS
ITA
DAN