Transtar 6091 MSDS - Auto Body Toolmart

PRODUCT DATA6091,60941K Low VOC Speed SealerSUITABLE SUBSTRATES:1K and 2K Primers, Old Paint Finishes, Fiberglass, SMC, Galvanized steel * , Properlyprepared steel * & aluminum * , and OEM replacement parts (sanded).Surface preparation:1. Finish sand all areas to be sealed with 500 - 600 grit or finer sandpaper.2. Clean with SCAT (TDS222), Speedi SCAT (TDS223) or Aqua SCAT 2 (TDS225).3. Provides good adhesion and corrosion protection when applied directly to bare metal.For areas larger than 1’ X 1’, apply one of Transtar’s direct to metal primers (Self-Etch (TDS209), Epoxy Primer (TDS208) or Kwik Prime (TDS213) per instructions indicated on product data sheet.APPLICATION & Mixing:The product is supplied ready-to-spray. Reduction is not required. Stir or agitate thoroughly and filter before using.Wet-on-wet: Apply one to two full wet coats to achieve hiding (.75 to 1.0 mil film build). Flash 5-10 minutes betweencoats. Avoid heavy applications. Allow sealer to flash for 10-15 minutes (@75° F (24°C)) prior to topcoating.Recoatability/Repair: If sealer is not top coated within 8 hours, clean, scuff (with 600 grit or finer sandpaper) beforetop coating.Tinting: 1K Low VOC Speed Sealer can be tinted up to 10% by volume using basecoat mixing toners for optimal hidingcapabilities.Note: If sanding is required to remove any imperfections, wet or dry sand using 600 - 1000 grit sandpaper. Use lightpressure to avoid cutting through sealer.Clean Up:Clean spray equipment immediately after using with compliant thinner and/or gun cleaner.SPRAY GUN SET UP:GUN TYPE FLUID TIP AIR PRESSURE FLUID PRESSURESiphon Feed 1.4 - 1.6 mm 40 - 50 PSI (at gun) n/aGravity Feed 1.2 - 1.6 mm 30 - 40 PSI (at gun) n/aPressure Feed 1.0 - 1.2 mm 40 - 50 PSI (at gun) 10 - 14 PSIHVLP/LVLP 1.2 - 1.4 mm 10 PSI max. (at aircap) n/a207See website (www-tat-co.com) for this document in other languages.Vea el Web site (www.tat-co.com) para este documento en español.Voir le site Web (www.tat-co.com) pour ce document en français.TRANSTAR AUTOBODY TECHNOLOGIES • 2040 HEISERMAN DRIVE, BRIGHTON, MI 48114 • (800) 824-2843FAX (800) 477-7923 • EMAIL: info@tat-co.comRev 07/11