Jerome Â® Communications Software (JCS) - Arizona Instrument

More documents

Recommendations

Info

5.3. Data Logger menuThe Data Logger is used to collect the data from the instrument, but first it must beprogrammed.To program the Data Logger:Connect the JCS Interface Cable as follows: Attach the connector marked “DATA LOGGER” to the Data Logger. Attach the connector marked “PC” to the computer. Attach the connector marked “INSTRUMENT” to the instrument. Turn the instrument ON. In JCS, click on the “Data Logger”drop-down menu, and then click on“Program.” The Program Menu allows setting ofthe sample interval and alarm setpointvalue into the Data Logger.‣ Do not use a short Sample Intervalthat would require more than 2regenerations per day. Try a 10 to15 minute sample interval initially.‣ Set the Alarm Setpoint if desired orleave it blank. A blank alarmsetpoint has the effect of turning offthe alarm.‣ Click on the Program button to setthe values into the Data Logger.Disconnect the JCS Interface Cable from the instrument and Data Logger.Attach the Data Logger directly to the instrument.‣ The Data Logger can be left unpowered for a few hours without losing its timeclock. Turn the instrument on every few hours for a few minutes to power theData Logger and retain the clock and programming.When you are ready to begin sampling: Turn the instrument ON Press the sample button.When finished sampling: Turn the instrument off.‣ Remove the Data Logger from the instrument and attach it to the JCS InterfaceCable connector marked “DATA LOGGER.”‣ Ensure the JCS Interface Cable’s “PC” connector is still attached to the computer.‣ Connect the JCS Interface Cable connector marked “INSTRUMENT” to theinstrument.‣ Turn the instrument ON.Page 14 of 24AZI Customer Service 602-470-1414, 800-528-7411, or support@azic.com
Click on “Data Logger” and then on“Retrieve Data.”Select the information for this samplingsession from the pull down tabs foreach line.Ensure the date and time are correct.Add a comment if desired.Click on the Retrieve button.‣ Data files stored in the Data Loggerwill be transferred into thecomputer.After the data is in the computer, theprogram loads the Data Form to allowyou to view the data on-screen.AZI Customer Service 602-470-1414, 800-528-7411, or support@azic.com Page 15 of 24
Page 1 and 2: AZI P/N 700-0042-BLast update May 2
Page 3 and 4: Jerome ® Communications Software (
Page 5 and 6: 2. SYSTEM REQUIREMENTSContents of t
Page 7 and 8: 3.2. Instrument to Data Logger to C
Page 9 and 10: Click on “Continue” to add the
Page 11 and 12: 4.4. Program Revision InformationCl
Page 13: 5.2. Setup menuThe JCS program uses
Page 17 and 18: A sample report is shown below.An e
Page 19 and 20: 5.5. Instrument menuThe Instrument
Page 21 and 22: 5.6. Window menuThis selection oper
Page 23 and 24: 6.2. Instrument operation from the

Jerome Â® Communications Software (JCS) - Arizona Instrument

Create successful ePaper yourself

Delete template?

Save as template?